ꦫꦣꦺꦤ꧀ꦄꦤ꧀ꦠꦱꦺꦤ

PATH: etc / sysconfig

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
#     enforcing - SELinux security policy is enforced.
#     permissive - SELinux prints warnings instead of enforcing.
#     disabled - No SELinux policy is loaded.
# See also:
# https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/9/html/using_selinux/changing-selinux-states-and-modes_using-selinux#changing-selinux-modes-at-boot-time_changing-selinux-states-and-modes
#
# NOTE: Up to RHEL 8 release included, SELINUX=disabled would also
# fully disable SELinux during boot. If you need a system with SELinux
# fully disabled instead of SELinux running with no policy loaded, you
# need to pass selinux=0 to the kernel command line. You can use grubby
# to persistently set the bootloader to boot with selinux=0:
#
#    grubby --update-kernel ALL --args selinux=0
#
# To revert back to SELinux enabled:
#
#    grubby --update-kernel ALL --remove-args selinux
#
SELINUX=disabled
# SELINUXTYPE= can take one of these three values:
#     targeted - Targeted processes are protected,
#     minimum - Modification of targeted policy. Only selected processes are protected.
#     mls - Multi Level Security protection.
SELINUXTYPE=targeted

[-] kdump [edit]
[-] atd [edit]
[-] samba [edit]
[-] grub [edit]
[-] man-db [edit]
[-] aibolit-resident-hyperscan [edit]
[+] modules
[-] crond [edit]
[-] run-parts [edit]
[-] network [edit]
[-] dovecot [edit]
[-] exim.rpmorig [edit]
[-] cpupower [edit]
[-] garb [edit]
[-] raid-check [edit]
[-] chronyd [edit]
[-] firewalld [edit]
[-] exim [edit]
[-] anaconda [edit]
[-] smartmontools [edit]
[+] ..
[-] nftables.conf [edit]
[-] sshd [edit]
[-] sysstat [edit]
[-] sysstat.ioconf [edit]
[+] network-scripts
[-] named [edit]
[+] console
[-] aibolit-resident [edit]
[-] rsyslog [edit]
[-] selinux [edit]
[-] rpcbind [edit]
[+] imunify360
[-] kernel [edit]
[-] httpd [edit]
[-] irqbalance [edit]
[-] htcacheclean [edit]